Long metal pin with a flattened point on one end and a circular flat head on the other. The shaft is round in cross-section, but not very straight--it has a number of bumps and bows along its length. Surface is pitted and powered with rust.

Hollow sheet bronze figure, filled with clay(?), base closed with sheet of same metal fastened with tabs and sealed clay. Male figure is seated cross-legged on double lotus base, hands in lap, palms up, right hand over left with thumbs touching; smiling with eyes open. Yellow-brown patina; face, feet hands and elaborate headdress are gilded. Headdress, earrings and draperies are from separate pieces of bronze stapled to figure. Back of headdress is painted red and blue; red and green paint in circles represent jewels. One drapery is detached; headdress is bent.

An arrow with a shaft (part a) made of rounded light brown wood. There is a small lance-olate-shaped iron arrow point (part b). A dried leaf fits through a slit at the end of the shaft. The arrow has an incised zigzag line(?) on one side.

An arrow with a shaft (part a) made of rounded light brown wood. There is a small lance-olate-shaped iron arrow point (part b) that has an incised line down the middle on both sides. A dried leaf fits through a slit at the end of the shaft.

Partially finished cap on knitting needles, with two colours of yarn attached. The knitting is mounted on four needles and the circular fabric is folded in half. The needles, including the fifth for transferring stitches, are lined up parallel and bound together with the unused yarn. Rows of geometric patterns in white, blue, and green, divided by thin blue lines. Checker effect of blue, red and white along edge.

Flat round wrist knife with leather shields. Leather strip covering outside is held on with iron clips. Leather covering on inside part of blade where wrist fits. Held on with copper wire wound around leather.

Large leaf-shaped nose ornament with soldered hook that loops through nose. There is an incision from base of the hook to centre of the face. The metal is bent out of shape at hook's base.

Large steel knife with round carved wooden handle. Triangular blade with point at right angles to handle. Sharp on all edges. Two holes in centre of blade.

An arrow with a shaft (part a) made of rounded light brown wood. There is a small lance-olate-shaped iron arrow point (part b). A dried leaf fits through a slit at the end of the shaft.

An arrow with a shaft (part a) made of rounded light brown wood. There is a small lance-olate-shaped iron arrow point (part b) that has an incised line down the middle on both sides along with six pairs of barbs below. A dried leaf fits through a slit at the end of the shaft. At the end of the shaft, there is a horizontal band that has four small grooves, and a simple finial at the end.