Thorn carving depicting a person worshipping a large carved face with a dish and bowl nearby. The person is shown on their knees, bowing down with hands held in prayer. Figure adhered to a rectangular pressed board base with a stamp on the bottom: "Isaac [illegible] Ibadan".

Thorn carving depicting two figures watching television. Figures adhered to a rectangular pressed board base. One figure is seated, and the other is leaning down to their level. The TV sits on a tripod base, and there are various dishes on the floor.

Thorn carving depicting a soldier in army fatigues. Full camouflage outfit with wide-brimmed camouflage hat. The figure holds a long-barreled gun across their body. The figure's feet are adhered to a Federation of Nigeria halfpenny(?) coin.

Thorn carving depicting a seated figure praying with a book open and a block with writing on all sides. The figure wears a long robe, and a tall pointed hat. They hold their hands out in front of them. Figure adhered to a rectangular pressed board base.

Wooden panel carved in mid-relief. Depicts a humanoid figure with arms raised, hands held in fists, and a exaggerated tongue hanging from their mouth. Short horns extend up from their head, and large wings spread out to each side. The legs are each snake-like, and each twist in a loop before ending at a reptilian foot.

Metal staff with a single bell at the top. Bell is pocket-shaped with wide flat side seams that are pierced with holes. Two metal rings are looped through different holes, one with two Federation of Nigeria Halfpennies from 1959 attached through their centre holes. A small phallic point extends from the staff's shaft below the bell.

Egungun headdress carved from a single piece of blackened wood. The base is dome-shaped with carved columns of small geometric shapes spaced by vertical lines. An arched crest extends from the top and is also carved with a continuation of the lower designs. The rim is decorated with a band of carved zigzags with a row of holes beneath.

Long stone adze(?) or tool with a rounded blade. The top is relatively flat, while the underside is rounded. Both top and bottom form a dual inclined plane terminating at a shallow rounded wedge blade. The opposite end is a dull point. The width gradually increases from the point to blade.

Stone tool or pestle(?). Carved from a single piece of stone. Simple design with one broad rounded end, and a relatively straight cylindrical shaft. End of shaft is broken.

Long stone adze(?) or tool with a rounded blade end. The smooth shaft is cylindrical on one end, then curves slightly while also tapering to a blade. The underside has a notable indent, then has a flat surface until the blade edge.