Flat bottomed kayak with slightly upturned stern and a long bow. A cavity has been hollowed out with a raised lip around it. There are nine holes pierced through the top, with two sinew threads passing through the set of holes on the bow, and it appears that there were more sinew threads originally.

Sled (a) made from the lower jaw bones of a caribou, with teeth intact. There is a cross-bar lashed onto the back of the sled below the handles. The rawhide traces are tied onto the front of the sled and have worn through so that the team is not connected. Each member of the 'dog' team (c-e) is represented by a uncarved humerus seal bone wearing a rawhide harness with a long strip attached. The whip (b) is made of thin pieces of carved bone with a long rawhide strip lashed with thread.

Carved wooden snow goggles contoured to fit the face. The narrow eye slits are blackened on the inside. The braided sinew strap is attached on each side. Tag attached.

Quiver made from four pieces of sealskin stitched together with sinew there is a large opening at the top which is cut on a slant. The bottom has been permanently creased. There are eleven holes along one side, and through two of these are sinew cords which attach to a curved bone handle. Three smaller pieces of bone are attached for decoration.

Cable-backed bow made from wood and other materials. There are 2 places where thin pieces of bone have been attached to either side of the wood with copper pins, one has sealskin sewn over the top of the bone, and the other has sinew lashed over it. There are knobs on either end of the bow, around which 8 braided sinew cords are strung. The cords are lashed onto the wood in 2 places, and they are twisted and wound with sealskin in the middle section. (Bow string no longer attached.)

The triangular copper arrow point is inserted in a bone shaft and held in place by three copper pins with a wedge of slightly different material that has been added on. The bone shaft is inserted in the wooden one and lashed on with sinew. About 5cm. above this, a v-shaped cut has been made through the shaft and a glue-like substance used to hold it together. There is another cut about 30cm. above it which is held together with sinew lashed around it. The end is notched and there is sinew wrapped around it.

The metal arrow point is slender with rounded edges. The shaft is also metal and has squared edges, the underside of which is hollowed out. It is inserted in a wooden shaft and lashed on the sinew cord. One-third of the way along the shaft there is a nick out of it. 10cm. below the end a v-shaped cut has been made through the shaft and a glue-like substance used to hold it together. The end is notched.

Quiver made from seven pieces of sealskin stitched together with sinew. The bottom is slightly rounded and the top folds over all the way around. The bottom is slightly rounded and the top folds over all the way around. Along the lengthwise seam there are four holes. Near the top, there is a leather thong which forms a handle. There are two pieces of antler strung on it.

Diamond-shaped copper arrow point. It is inserted into a wooden shaft and lashed with sinew cord which is beginning to unwrap. The end of the shaft is notched and lashed with sinew.

The small triangular shaped tip has a blunt end and a long shaft with square edges made from one piece of copper. It is inserted in the wooden shaft and lashed on with sinew cord. The end is notched.